Creation & Configuration
Last updated
Last updated
With aqua, you can run automated tests. The procedure for running an automated test is the same as for a manual test. You simply click on the Run button in a given test case. The following dialogue is supplemented by a section for selecting an agent. The Agent is responsible for running the test.
🔴 Red indicates that the agent is unavailable.
🟢 Green indicates an execution agent waiting for a task.
The following chapters describe how to configure the agents using the web client for:
PowerShell
Unixshell
Jenkins
To set up additional automation tools such as Ranorex, JMeter or SoapUI, or even database queries, you will need to use the aqua dekstop client. Please refer to the automation chapter for the Desktop Client: article for further information.
To run an automated test case, an aqua agent must be configured. Each agent has a unique access code. The code is generated in aqua and assigned to the agent. The agents can then be installed on any computer as long as there is a connection to the aqua server. Once installed and configured, the agents simply communicate between aqua and the respective automation tool, starting test executions and returning results to aqua.
To retrieve an Access Key, select your project in the Project Browser and click on the hamburger menu on in the top left corner of the aqua header, or simply right-click on the project name. In the Project Configuration area, select Automation Agents.
Then in the agents tab, select 'Configuration' and then 'Add agent'. Next, give a unique name to your agent.
An Access Key is automatically generated and is required to successfully configure an Agent. Copy the passcode to the clipboard or write it down for later use. The passcode is used as an identifier to properly differentiate between multiple Agents.
Never configure two Agents with the same passcode.
The Access Code is required to configure the Agents. It must be included in the config file of the appropriate agent.
To download the agent package, please navigate to download section, available under the side menu and then select 'aqua Downloads'.
Or undet the integrations page click on the 'Installation files' option.
Another required piece of information is the aquaServiceUrl, which can also be found on the download page.
Once you download the agent package, the config file is located in the same folder as the agent exe file, for example aquaAgentPowerShell.exe.config for PowerShell or aquaAgentRanorexGui.exe.config for Ranorex.
The generated access code must be entered in this file. Other configurations can also be made in this file, depending on the agent type. In addition to the agentCode, the aquaServiceUrl needs to be provided as well. The correct aqua server name or server IP address must be entered there.
The relevant sections are shown in the following snippet, using the PowerShell agent as an example:
Once you have correctly configured the Agent, you can start the Agent from the .exe file. The window that opens will show the connection status and other log messages.
In the Automation Agents section in aqua:
🟢 green dot will be displayed for this agent if the connection is successful (the view may need to be refreshed once)
🟠 If a connection has been made at least once, but is now lost, an orange dot will appear.
If there is no connection, check whether the agent was started, whether error messages are displayed in the agent, and whether there is any connection to the aqua server. To run an automated test case with this agent, the agent must be started and configured correctly.
If an initial connection cannot be made, the dot will be grey.
